Stainless Steel Plate Heat Exchanger And Process Combination

  The stainless steel metal corrugated plates of the plate heat exchanger are assembled in an inverted manner, so that a mesh contact can be formed, Stainless steel plate heat exchanger and process combinationso that the fluid in the channel becomes a mesh fluid.Stainless steel plate heat exchangers are made of stainless steel or titanium alloy plates and are resistant to various corrosive media. The rubber pad of the heat exchanger can be replaced at any time, and it is convenient to install, disassemble and overhaul.

  The stainless steel plate heat exchanger plate is an independent element, and the flow can be increased or decreased as required. It can be applied to various and technological requirements.The sealing groove of the stainless steel plate heat exchanger is provided with a drain liquid channel, and various media will not communicate. Even if a leak occurs, the media is always discharged.The process combination form of the stainless steel plate heat exchanger should be calculated according to the heat exchange and fluid resistance, and determined under the requirements of the process conditions. The heat exchanger is designed to make the convection heat transfer coefficients in the cold and hot water flow channels as equal or close as possible, so as to obtain better heat transfer effect.Because the convective heat transfer coefficients on both sides of the heat transfer surface are equal or close to each other, the heat transfer coefficient obtains a larger value.Although the flow rate between the plates of the plate heat exchanger is not equal, the average flow rate is still used for the calculation of heat transfer and fluid resistance.