What is the cleaning process of stainless steel plate heat exchanger

  The stainless steel plate heat exchanger is composed of a plate with many corrugations. The plate has four corner holes for the two liquids to pass What is the cleaning process of stainless steel plate heat exchangerheat. The plate is installed in the frame of the fixed compression plate and the movable compression plate, and is clamped with clamping bolts. The plate and the movable compression plate are suspended on the upper guide rod and positioned by the lower guide rod, and the rod end is fixed on the support column. The fixed compression plate, movable compression plate, guide rod, bolt, nut, and front support can be collectively referred to as the frame of the plate heat exchanger. What is the cleaning process of stainless steel plate heat exchanger?

(1) Clean water discharge in isolation equipment system and heat exchanger

(2) Use high-pressure water to clean the pipeline to retain impurities such as sludge and algae

(3) Install a ball valve (less than 1 inch = 2.54 cm) between the isolation valve and the exchanger. Both the inlet and return ports should be installed

(4) Connect the delivery pump and connecting pipe to make the cleaning agent pump from the bottom of the heat exchanger and flow out from the top

(5) Start pumping the required Fostertech cleaning agent into the heat exchanger (the proportion is adjusted according to the specific situation)

(6) Recommended cleaning time for repeated cycle cleaning

(7) Check the effectiveness of the cleaning agent at regular intervals using PH test paper

(8) Recover the cleaning solution within the cleaning time

(9) Complete the cleaning and start-up operation

(10) When the equipment is running stably, record the current data such as medium flow, working pressure, heat exchange efficiency and other data